CRF250L Sidecar

[Lapchik]

Here are all the pictures
https://www.facebook.com/pg/KorysRides/p...0220542424

[Lapchik]

[Lapchik]

If you can't see the pictures, they are on the Kory's Rides Facebook page and on ADV Rider. These images are linked to ADV Rider so you need to be logged in there to see them [I think?]

There are a couple more videos on my YouTube page. Here are some pictures of the frame I'm building for the bike-side attachments.

Front end brackets



Rear engine bolt secures the rearward lower mounting point



Clearance'd for the brake lever



Frame all tacked together. Once I have it welded a little more, I'll put some gussets in, test fit again, then take apart and fully weld it.



View from the top. I can still change the oil and service the clutch without having to remove anything. The holes at the rear are for plug welds. I don't have enough pipe to remake that piece, and rather than buy more and keep trying angles I just did a slug-n-plug joint for it. There's a solid rod inside to keep it strong. The other joints don't have that, but the rear one will probably have a connecting arm attached at or on it.

[Lapchik]

Two update videos. I'll take pictures tomorrow when the lighting is better. Episode 11 is actually old footage I forgot to use to make an episode, so it's actually 20th in the playlist.

[Lapchik]

[Lapchik]

[Lapchik]

   

   

   

Click image to make it larger

[Lapchik]

   

[Lapchik]

[Lapchik]

There are a few more videos on my YouTube page now, but most of what is going on now is short rides for a few blocks and then adjusting the alignment. The kids seem to like it though.

   

   

[Cruzin]

Quite the little character

[Lapchik]

Last update! I won't be making a video for painting the frame and that's all that's left to do on it.